Mygsmtube 138-removing-an-ic-with-hot-air-gun

	How to remove UEM

Removing an IC with Hot Air Gun

Full Screen

Discussion

About this video

admin

Date :20 January 2009

Votes :0

Rating :0

Vote it:

This board was faulty for some undetectable reason so we need to pull the IC off, clean up the PCB and the IC and then mount the IC back on. This video shows heating up the four sides with a circular motion of the air gun and slightly lifting on the IC. We use lead free solder paste so it takes a bit of time for the solder to release. Notice I am not lifting hard enough to raise the PCB - give the IC time to let go of the PCB on its own. [More] [Less]

Tags:

Sort By

Videos in "Hardware" category

	Sony Ericsson W... How to change an LCD in Sony Ericsson W880i
	Sony Ericsson K... Show you how to replace Sony Ericsson K800i LCD Screen
	SOLDERING FLAT ... Here is how to solder the flat ribbon cable to the pcb of the PSP. Use a lo...
	SMD Reflow Sold... SMD Reflow soldering
	Sim Tray Removi... Sim Tray Removing
	Replacing the f... Lay down newspaper (the old glass may splinter some when removing). I used ...
	Removing an IC ... This board was faulty for some undetectable reason so we need to pull the I...
	Professional SM... Advanced surface mount, vertical drag soldering at Washburn Computer Group ...
$Video Info::<table><tr><td width='30%' valign='top'>Title</td><td width='1%' valign='top'>:</td><td width='89%'>Nokia N95-8GB Loose Slider Fix</td></tr><tr><td valign='top'>Details</td><td valign='top'>:</td><td>Update 16.02.08 (Read this) Tape used in video is a bit to thick. Be very accurate and careful with the tape piece or else it wont stick to the plastic rail properly. How to fix loose slider on a Nokia N95-8GB, its a bit different/harder than fixing a regular N95. This is probably the fifth time I do this and this mod seem to be very good. Same smooth slide without the annoying click on the left side of the screen. Cons and pros. +Removes the loose slider on right side. +Easy to do. +Does not require any special tools. -May fracture the guarantee. -Its possible to break something if not careful enough. -It does not remove the very little looseness on the y axis. Enjoy =)</td></tr><tr><td>Category</td><td>:</td><td>Hardware</td></tr><tr><td>Views</td><td>:</td><td>2014</td></tr><tr><td>Votes</td><td>:</td><td>2</td></tr><tr><td>Rating</td><td>:</td><td>5</td></tr><tr><td>Downloads</td><td>:</td><td></td></tr><tr><td>Added by</td><td>:</td><td>admin</td></tr><tr><td>Date</td><td>:</td><td>2009-03-14 02:22:02</td></tr></table>$	Nokia N95-8GB L... Update 16.02.08 (Read this) Tape used in video is a bit to thick. Be very a...
	Nokia N73 LCD S... Show you how to replace Nokia N73 LCD Screen

Jump to: / 4

Visitors

	Today	1030
	Yesterday	1801
	This week	1030
	This month	9750
	All	613423

Mygsmtube

Video Categories

Visitors